At last, the uncovered portion of the drywall seam is torn, shrinks and overall ruins the look of your drywall tape.

If you have already painted your drywall tape and are not able to observe any bubbles in it, it is still suitable to follow the steps discussed above in this article to overcome the issue. Drywall should be cut with a utility knife and then press it firmly into the joint compound and use a putty knife to spread the compound evenly over the tape.

If you have used too much joint compound, then it is important to scrape it down with a drywall trowel after being dried off. There are several reasons why bubbles may form in drywall tape, but with careful attention to detail and proper technique, many of these issues can be avoided. It is also important to use the appropriate type of tape for the specific job. Ensure proper tape usage:

To make the new tape blend seamlessly with the premixed joint compound, use a putty knife to smooth it over the surface. Now Wait 24 hours for the joint compound to dry, then sand and apply additional coats of joint compound.Cut through the tape on both sides of the bubble and remove the affected portion of the tape to fix the bubble. You can expect the perfect and smooth drywall from expert drywallers but still, it can be done by yourself by following the process discussed in this article. How To Fix a Bubble in Drywall Tape? 8 Easy Ways Explained! Once you’re done with chipping off the thin layer of the dried joint compound, it’s time to cut out the section of bubbled tape. It is very simple to fix these annoying bubbles in Drywall mud. You simply need a putty knife, utility knife, joint compound and lastly a roll of paper tape and you can complete this fixing process easily. Sugar Free Very Berry – A dentist-recommended version of Bubble Tape, a mix of grape and blue raspberry

To obtain the best result and perform the process effectively, you need the below tools. Tools Required Thus, if any inexperienced person is facing this problem then just consider it as a common situation. Make sure you use enough joint compound and keep good ventilation in your room when using these tapes. This will help reduce humidity levels which can cause air bubbles. With correct installation and proper care, you can easily get rid of bubbles in your drywall tapes. First, I want to clarify that this step should not be performed if the joint compound is yet to be dried and a bubble in drywall tape is noticed. Apply some more joint compound to smoothen the wall even more and repeat this step until the desired texture is seen. Cut a New Piece of Drywall Tape to the Length of the GapNow that the drywall tape is cut to size, it’s time to install it. Start by lightly misting the area around the gap with water. This will help activate the adhesive on the tape and make it more malleable.

Most professional drywallers admit that because of the bad installation operation, bubbling in drywall tape happens. Then remove the air-bubbled part of the tape and put a joint compound and again paint it carefully. Is it Normal for Drywall Tape to Bubble? Fixing bubbles in drywall tape is not an impossible task and can be done easily by following the steps discussed above. All you need to have is some patience, the necessary tools, drywall joint compound and paper tape! use the appropriate strength for the job, apply the tape correctly by letting the adhesive set before finishing the joint, applying it properly to the surface, and ensuring it is the correct distance from the surface. Also, measure and mark the joint correctly. You need to chip off the joint compound which is completely dried carefully. Continue the process till the bubbled tape part is seen.

But yes! It is not wrong to say that bubbles in drywall tape definitely hamper the overall look of the wall if not renovated. You must take your time to get rid of all the air bubbles before applying paint over it otherwise it will ruin the overall look. Even if the bubbled portion of the tape is getting hampered, do not worry. This would be replaced in our next step. But ensure not to impact the nearby areas of the wall as it would make the whole process very much expensive. Cut Out the Section of Bubbled Tape